MA40G / MA60G Owner’s Manual Mixer Amplifier Important Safety Instructions The lightning flash with arrowhead symbol within an CAUTION equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the RISK OF ELECTRIC SHOCK product’s enclosure that may be of sufficient magnitude...
Page 4
2. Should any of the following irregularities occur during use, immediately switch off the power, disconnect the power cord from the AC outlet and contact Atlas Sound. Do not to attempt to continue operation with the device as this may cause fire or electric shock: •...
Speaker Out The LIMIT LED will illuminate when the MA40G/MA60G is in a clipping condition, caused by excessively high input levels or a GAIN control is turned up too high. An occasional flash is OK. Check that the proper signal level is being fed into the Sense inputs and/or turn the input gain down until the LED is no longer illuminated.
MA40G / MA60G Owner’s Manual Mixer Amplifier 4. Input 1 Gain Input 1 level control potentiometer varies the amplitude of the signal fed into the amplifier. Turn clockwise to increase and counter-clockwise to decrease the signal level. 5. Input 2 Gain Input 2 level control potentiometer varies the amplitude of the signal fed into the amplifier. Turn clockwise to increase and counter-clockwise to decrease the signal level.
Security Cover Rack Mount Kit Option The MA40G & MA60G can be rack mounted as a single unit or with two units together. To do so a PA702RMK Rack Mount Kit needs to be purchased from Atlas Sound. 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
The enclosed load chart will provide the information to determine if the load or speaker system impedance is too low for the amplifier's rating. In every install it is always recommended to measure the load prior to turning the system on to be sure the system is installed correctly. MA40G & MA60G Max Load Chart Speaker MA40G...
Page 9
MA40G / MA60G Owner’s Manual Mixer Amplifier Measuring a Speaker System's Impedance Note: It is important to only use an Audio Impedance Meter and not a conventional Volt/Ohm meter. A true audio frequency impedance meter is essential for reliable installation of background music and paging systems in residences, office buildings and public areas. Avoid costly service calls and amplifier damage by verifying actual speaker system impedance prior to operation. Unlike conventional volt/ohm meters, which measure DC resistance, an Audio Impedance Meter unit utilizes an internal...
LIMITED TO WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Atlas Sound does not assume, or does it authorize any other person to assume or extend on its behalf, any other warranty, obligation, or liability. This warranty gives you specific legal rights and you may have other rights which vary from state to state.
Need help?
Do you have a question about the MA40G and is the answer not in the manual?
Questions and answers