Table of Contents
Advertisement
Getting started
Adding and registering headsets
Register a headset to the Synapse SB67030/SB67031 deskset
1.
Press MENU on the deskset.
Scroll to User Settings, then press SELECT.
2.
3.
Scroll to Cordless Settings, then press SELECT.
Scroll to Headset, then press SELECT.
4.
Make sure the screen shows Cordless Headset is currently
Not Registered before registration.
If the screen shows Cordless Headset is currently Registered,
there is already a registered cordless headset. Refer to the
deregistration instructions on page 16 to deregister the old
headset before registering a new one.
5.
On the deskset, press Register. The screen displays
Registration in Progress... while the deskset is searching for
the headset.
6.
Lift the headset from the headset charger, then replace it
to the charger. The headset
indicate it is registering to the deskset.
When registration is complete, the screen displays Cordless
7.
Headset is currently Registered.
It takes about 60 seconds to complete the registration process.
The
light turns red when the headset is registered but not fully
charged, or turns blue when it is registered and fully charged.
To verify the registration, press the
check for a dial tone. If the registration fails, you hear the voice
prompt, "Not registered" and the
slowly in red and blue.
If the registration was not successful, remove it from the headset
charger and try the registration process again.
light flashes red and blue to
button on the headset and
light on the headset flashes
10
Hide quick links:
Advertisement
Table of Contents
