Register A Headset To The Tl7810/Tl7812 Headset Base - AT&T TL7800 User Manual

Getting started
Adding and registering headsets

Register a headset to the TL7810/TL7812 headset base

1. Make sure the battery is properly installed in
the headset (see page 6). The
slowly in red and blue to indicate the headset
is not registered.
2. Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the headset charger.
4. Press and hold the PAIR button on the
headset base that you want to register this
headset to (about four seconds) until the
MUTE light on that headset base turns on and
then release the button.
5. Return the headset to the headset charger
for registration. The
in red and blue.
It takes about 60 seconds to complete the
registration process. The
when the headset is registered but not fully
charged, or turns blue when it is registered
and fully charged.
If the registration fails, you hear the voice prompt "Not
registered" when you press the
light on the headset flashes slowly in red and blue.
To reset the headset, remove it from the headset charger and try
the registration process again.
NOTE: You cannot register a headset if another system headset is in use.
light flashes quickly
The light turns red
9
light flashes
button on the headset, and the