Universal Garage Door Opener (Homelink ® ) - Chrysler Town & Country 2010 User Manual

UNIVERSAL GARAGE DOOR OPENER (HomeLink
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink
hand-held transmitter button until the HomeLink
from a slow to a rapidly blinking light, then release both the HomeLink® and the
hand-held transmitter buttons. This may take up to 30 seconds, or longer in rare
cases.
• Press and hold the just-programmed HomeLink
on constantly, programming is complete and the garage door should open.
• Your motorized door or gate will open and close while you are programming the
universal transceiver. Do not program the transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage or confined area while programming
the transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon Monoxide is poisonous when inhaled and
can cause you and others to be severely injured or killed.
NOTE:
• Only use this transceiver with a garage door opener that has a "stop and reverse"
feature as required by Federal safety standards. This includes most garage door
opener models manufactured after 1982. Do not use a garage door opener without
these safety features. Call toll-free 1–800–355–3515 or, on the Internet, at
www.HomeLink.com for safety information or assistance.
• If you are having difficulty programming your HomeLink
opener was manufactured after 1995, you may have a rolling code. Follow the steps
below for Programming A Rolling Code System.
ELECTRONICS
Programming HomeLink
Begin Programming
• The HomeLink
overhead console.
• Erase all channels before you begin
programming by holding the two outside
buttons for up to 20 seconds until the red
indicator flashes.
®
indicator flash rate changes
®
button; if the indicator light stays
WARNING!
45
®
®
®
buttons are located in the
®
®
button and the
®
and your garage door
)
buttons