Daily Starting Checklist - Quincy Compressor QR-25 Series Instruction Manual

..
-.—.... . . —.
---- ... . - .. . .. ,-.. ..-.——. ————
operation check belt tension, oil level, and inspect the system for leaks.
Daily Starting Checklist
Do not proceed until the Pre-starting Checklist and Initial Starting &
Operating sub-sections have been read and are thoroughly understood.
Step 1)
Step 2)
Step 3)
Step 4)
Step 5)
Step 6)
Step 7)
Step 8)
Step 9)
Check oil level in crankcase.
Drain liquid from the air receiver and moisture trap (if so equipped).
Turn on cooling water (watercooled units)
Jog the starter button and check compressor rotation.
Note:
Continuous Run Units - Prior to starting a continuous run unit,
pull the ring attached to the pilot valve out and turn the finger nut
in (clockwise) until it seats against the pilot housing. Now the
compressor can be started unloaded. Once the compressor is
running at full speed, the finger nut on the pilot valve can be turned
out (counterclockwise) until it seats against the pull ring.
Start compressor per factory instructions. (Refer to SECTION 4,
Pre-Starting Checklist and Initial Starting& Operating. )
Check system pressure.
Check cooling fan.
Check all pressure relief valves for proper operation,
Check control system for proper operation.
QR-25 Series
QUINCY COMPRESSOR
52201-104
17
February 1994