AUSTRALIAN MONITOR MX 82 Installation And Operation Manual

AUSTRALIAN MONITOR MX 82 Installation And Operation Manual

8 channel stereo mic/line mixer

Advertisement

Quick Links

M X 8 2
8 C HA NN EL S T ERE O MI C /LI NE M I XER
INSTAL LATI ON AN D O P ERAT I O N MA NUA L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MX 82 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AUSTRALIAN MONITOR MX 82

  • Page 1 M X 8 2 8 C HA NN EL S T ERE O MI C /LI NE M I XER INSTAL LATI ON AN D O P ERAT I O N MA NUA L...
  • Page 2 Do not parallel- or series-connect an amplifi er output with any other amplifi er output. Australian Monitor Inc is not Always operate the unit with the AC ground wire connected to the responsible for damage to loudspeakers for any reason.
  • Page 3: Table Of Contents

    I N T R O D U C T I O N A N D C O N T E N T S INTR ODU CTION The MX82 is an 8 channel stereo audio mixer that operates from 110/230-240 VAC @ 50/60 Hz. The MX82 offers high quality audio performance & a wide array of features in a standard 1 RU size.
  • Page 4: Front Panel

    F R O N T PA N E L GAIN TRIM MASTER This control is used to adjust the input gain and affects both the XLR and This pot controls the overall mixed output level for both left and right the RCA inputs.
  • Page 5: Rear Panel

    R E A R PA N E L CHANNEL INPUTS IEC MAINS INPUT SOCKET Channels 1 to 4 are mic/line switchable XLR balanced inputs. It accepts mic This is a standard IEC 3 pin socket. It accepts a standard IEC mains cable, or line level signals depending on the gain switch position.
  • Page 6: Inter Na L Adj Us Tment S

    - 2 Priority Muting modules for left and right outputs CHANNEL BUS SELECT ON/OFF MASTER OUTPUT See your local Australian Monitor dealer for more information. This jumper is provided for each of the fi rst 4 channels. The jumpers are located near the front of the unit.
  • Page 7: Ins Tallat Io N & T Rou Bles Hoot Ing

    I N S TA L L AT I O N A N D T R O U B L E S H O O T I N G INPUT CONNECTIONS For wiring balanced in, pin 2 is hot. Unbalanced wiring on the microphone inputs is not recommended.
  • Page 8: Bas Ic S Et Up And Op Erat Io N

    B A S I C S E T U P A N D O P E R AT I O N CONNECT THE OUTPUTS The inputs of the MX82 can accommodate a wide range of sources including dynamic microphones, DVD and CD players. The output may be Turn the amplifi...
  • Page 9: Dimens Ions

    D I M E N S I O N S M X 8 2 I N S TA L L AT I O N & O P E R AT I O N M A N U A L PA G E 9...
  • Page 10: Block D Iagram

    B L O C K D I A G R A M PA G E 1 0 M X 8 2 I N S TA L L AT I O N & O P E R AT I O N M A N U A L...
  • Page 11: Sp Ecifications

    S P E C I F I C AT I O N S FREQUENCY RESPONSE 20Hz - 20kHz (+0,-3dB) TOTAL HARMONIC DISTORTION < 0.1% @ 1kHz SIGNAL TO NOISE RATIO > 90dB (all pots at centre position) CROSSTALK >70dB +/- 12dB TONE CONTROLS BASS @ 100HZ TREBLE @ 10KHZ...
  • Page 12 AUSTRALIA AND NEW ZEALAND w w w. a u s t r a l i a n m o n i t o r. c o m . a u SYDNEY MELBOURNE BRISBANE ADELAIDE PERTH AUCKLAND (SA & NT SALES) (NSW &...

Table of Contents