Husqvarna DT22 Operator's Manual page 44

22. Wire tie the cable to the handle. See Figure10.
FIGURE 10
23. Check adjustment of clutch cable. If cable
needs adjusting, the adjusting should be
done at the lower end with the spring.
Adjust as follows:
Pull the clutch bail tightly against the handle.
The spring stretch should be 3/8" - 1/2".
If this range is not met, the adjustment should be
done closest to the spring.
24. Replace belt cover.
DO NOT use or start the engine until the
catcher bag is in place.
Machines equipped with a catcher MUST
not be used with defective catcher bags or
without the catcher bag in place.
They pose a risk of thrown stones, eye in-
jury and inhalation of dust.
44
BAGGER ASSEMBLY
WARNING!
WARNING!
25. Fit catcher bag to the bag frame as follows:
• Affix the bag's plastic rails to the frame.
• Install the upper portion of the bag be-
tween the two struts on the upper portion
of the frame and affix the bag to the front
edge of the frame.
• Press on the snaps, one on each side.
See Figure 11.
DT17
26. Attach bag to unit.
FIGURE 11
FIGURE 12
8011-284
8011-283
DT18