Safety - Trigon Dialog Owner's Manual

Preamplifier
Table of Contents

Advertisement

standard feature and a clearly legible display makes it possible to explore all the
possibilities of the unit. Without a micro-computer all this would be impossible.
From time to time it may be necessary to update the base unit's software. For this
purpose, a USB socket (19) is located on the back of the unit. This software is
provided free of charge and available for download on our website (more on that
later). Software updates will be necessary whenever a newly developed module, that
did not exist at the time of purchase of your DIALOG is to be used. The currently
loaded software version is displayed in the info menu of DIALOG. On our website you
can find the latest software version, and determine whether an update is needed.
The DIALOG's chassis of is mostly made of solid aluminum. To minimize
microphonics, a mix of materials such as steel, aluminum and wood (MDF) is used
in certain areas. The top cover, for example, consists of a sandwich of steel and
aluminum and is acoustically "dead" in the critical frequency range. The feet use a
diaphragm spring principleand decouple the DIALOG effectively from the surface on
which it rests.
The outboard main PSU contains separate supplies for audio electronics and control
electronics. In addition to this, another analog power supply used exclusively for the
audio circuitry is connected downstream in the base unit to avoid any potential
contamination of audio signals.
The TRIGON DIRECTOR system remote control operates the main functions and
features of the peamplifier.

2.1 Safety

TRIGON ELEKTRONIK GMBH assumes no liability for any damage caused by
improper handling, or failure to follow safety instructions.
Amplifiers must not be installed in close proximity to heat sources such as radiators,
stoves, high power light sources, open flames, etc... and should not be exposed to
severe shocks or vibrations.
Do not connect any electronic device to AC mains immediately after transport from
the cold into a warm environment. Condensation may occur and cause damage to
the device. Please wait until the unit has reached room temperature.
The amplifier should not be exposed to direct sunlight.
Make sure to install the unit with enough space for proper ventilation.
Never operate the equipment without the protective housing cover. Before opening
the unit remove the AC plug from the socket.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dialog and is the answer not in the manual?

Table of Contents