Ariens Zoom XL 915111 Owner's/Operator's Manual page 25

PROBLEM PROBABLE CAUSE
PTO or 1. Operator presence
mower
blades do
not engage
2. Faulty operator
or shuts off.
3. Electric clutch
4. Faulty PTO belt.
5. Faulty PTO switch,
Engine 1. Engine oil level
overheats.
2. Cooling system
3. Faulty engine.
Unit moves 1. The parking brake
with engine
off and
2. Faulty parking
parking
brake
engaged.
Hour meter 1. Ignition key is in
continues
when
engine not
running.
Unit does 1. Incorrect tire
not travel in
a straight
2. Steering levers
line.
3. Hydrostatic
Unit creeps 1. Hydrostatic
with
steering
levers in
neutral
position.
switch not
depressed.
presence switch.
connector is loose
or disconnected.
wires, connectors,
or clutch.
low.
plugged.
needs adjustment.
brake.
the run position
with engine turned
off.
pressure.
need adjustment.
transmission
and/or linkage
needs adjustment.
transmission
and/or linkage
needs adjustment.
CORRECTION
1. Depress operator presence switch by
sitting on seat.
2. Contact your Ariens Dealer.
3. Connect the electric clutch connector.
See REPLACING HYDROSTATIC BELT
on page 22 for the electric clutch
connector location.
4. Replace PTO belt (see REPLACING PTO
BELT on page 22).
5. Contact your Ariens Dealer.
1. Add engine oil. Refer to Engine Manual
for detailed instructions.
2. Clean cooling system. Refer to Engine
Manual for detailed instructions.
3. Contact your Ariens Dealer.
1. Contact your Ariens Dealer.
2. Contact your Ariens Dealer.
1. Turn ignition key to the off position.
1. Check tire pressure (see
SPECIFICATIONS on page 27)
2. Adjust steering levers (see Forward and
Reverse Speed Adjustment on page 21)
3. Contact your Ariens Dealer.
1. Contact your Ariens Dealer.
GB - 25