Caution And Operation Confirmation Indications - Sony PMW-F55 Operating Instructions Manual

Warning indication
on LCD/viewfinder
Insufficient Voltage
EXT. I/F Signal Error

Caution and Operation Confirmation Indications

The following caution and operation confirmation indication may be displayed on the center area of the
screen. In this case, please see the following table.
Indication
Battery Error
Please Change Battery
Backup Battery End
Please Change
Unknown Media(A)
Please Change
Cannot Use Media(A)
Unsupported File System
Media Error
1)
Media(A) Needs to be Restored
Media Error
Cannot Record to Media(A)
Media Error
Cannot Use Media(A)
1)
Media(A) Error
Recording Halted
Playback Halted
Media Reached Rewriting Limit
1)
Change Media (A)
Copy All MPEG2 Proxy
NG: Reached Clip Number Limit
NG: Same File Already Exists
NG: Not Enough Capacity
Input AES/EBU is Invalid Emphasis Emphasis signal that is not compatible with the AES/EBU input is input.
Input AES/EBU is not Pro Use
Fan Stopped
100 Error/Warning Indications
Buzzer REC
lamp
Continuous Rapidly
flashing
– –
Cause and measures
An error was detected with the battery pack.
Replace the battery pack with a normal one.
The remaining power of the backup battery is insufficient.
Replace the battery pack.
A partitioned memory card or one that contains recorded clips exceeding the
1)
number permitted with this camcorder is loaded.
This card cannot be used with this camcorder. Remove it and load a compatible
card.
1) A card of a different file system or an unformatted card was inserted. It cannot
be used with this camcorder.
Replace it or format it with this camcorder.
An error occurred with the memory card. The card requires restoration.
Restore the card.
Recording cannot be done, because the memory card is defective.
1) Because playback may be possible, it is recommended to replace it with another
card after copying the clips, as required.
Neither recording nor playback can be done, because the memory card is
1) defective.
It cannot be operated with this camcorder. Replace it with another card.
Recording or playback stops, because an error occurred with the memory card.
If this frequently occurs, change the memory card.
The memory card comes to the end of its service life. Make a backup copy and
replace the card with another one as soon as possible. Recording/playback may
not be performed properly if you continue to use the card.
For details, refer to the operating instructions of the memory card.
Copying of All the MPEG2 Proxy is not completed because of the displayed
reason.
• The maximum number of clips is reached.
• There is a file with the same name.
• There is not enough capacity for copying.
Replace the Media.
The camcorder is compatible with 50u-15u Emphasis only.
Signal other than Professional Use is input to the AES/EBU input.
The camcorder is compatible with Professional Use only.
The fan in the camcorder has stopped.
Avoid use under high temperature conditions. Turn the camcorder off and
contact a Sony service representative.
Cause and measures
The DC IN voltage is too low (stage 2). Recording cannot be
performed.
Connect another power source.
An error was detected with the signal in the mounting terminal
for an expansion unit.
Check the connection to the AXS-R5, etc.