Caution And Operation Confirmation Indications - Sony PXW-X180 Operating Manual

Caution and Operation Confirmation Indications

The following caution and operation confirmation indications may be displayed on the center area of the
screen. In this case, please see the following table.
Indication
Battery Error
Please Change Battery
Backup Battery End
Please Change
Unknown Media(A)
Please Change
Cannot Use Media(A)
Unsupported File System
Media Error
Media(A) Needs to be Restored
Media Error
Cannot Record to Media(A)
Media Error
Cannot Use Media(A)
1)
Media(A) Error
Recording Halted
Playback Halted
Media Reached Rewriting Limit
1)
Change Media (A)
Copy All MPEG2 Proxy
NG: Reached Clip Number Limit
NG: Same File Already Exists
NG: Not Enough Capacity
Invalid setting value was reset:
Media/Clip Naming/Camera
Position
Please save All File again
1)
"Media(B)" for the card in slot B.
102 Error/Warning Indications
Cause and measures
An error was detected with the battery pack.
Replace the battery pack with a normal one.
The remaining power of the backup battery is insufficient.
Replace the battery pack.
1) A partitioned memory card or one that contains recorded clips exceeding the
number permitted with this camcorder is loaded.
This card cannot be used with this camcorder. Remove it and load a compatible
card.
A card of a different file system or an unformatted card was inserted.
1)
It cannot be used with this camcorder. Replace it or format it with this
camcorder.
An error occurred with the memory card. The card requires restoration.
1) Restore the card.
Recording cannot be done, because the memory card is defective.
Because playback may be possible, it is recommended to replace it with another
1)
card after copying the clips, as required.
Neither recording nor playback can be done, because the memory card is
1) defective.
It cannot be operated with this camcorder. Replace it with another card.
Recording or playback stops, because an error occurred with the memory card.
If this frequently occurs, change the memory card.
The memory card has come to the end of its service life.
Make a backup copy and replace the card with another one as soon as possible.
Recording/playback may not be performed properly if you continue to use the
card.
For details, refer to the operating instructions of the memory card.
Copying of all the MPEG2 Proxy is not completed because of the displayed
reason.
• The maximum number of clips is reached.
• There is a file with the same name.
• There is not enough capacity for copying.
Replace the Media.
The setting value of "Clip Naming" is reset because an incorrect All file is
loaded.
Save the All file again after setting the desired setting value.