Simrad RD68 Service Manual page 49

7 PROGRAMMING AND CONFIGURATION
Introduction
All Transmitting / Receiving characteristics of the RD68 Series radiotelephones
are stored in Non Volatile Memory (NVM). The NVM of any RD68 Series radio
can be programmed with new characteristics using the programming kit, Part
Number PR68.
The following features are available:
COUNTRY
SECOND MODE
SCANNING
CHANNEL 10 SCAN
DUAL WATCH
TRI WATCH
ALTERNATE SCAN
FIRST KEY BEEP
STARTUP CHANNEL
WATCH CHANNEL
USA / CANADA
WEATHER CHANNELS
Selects primary mode. NVMs with INT
(International) selected for the FIRST
COUNTRY flag will receive on the INT Rx
frequencies. The radio can be switched to
USA with weather channels if the
BACKLIGHT key is depressed on power up
unless the SELECTED MODE ONLY flag is
set.
(SECOND MODE – YES).
Enables or disables switch to USA with
weather channels.
Enables or disables SCAN and MEMORY
SCAN functions.
Enables or disables Channel 10 from SCAN
function.
Enables or disables DUAL WATCH function.
Enables or disables TRI WATCH function.
Enables or disables ALTERNATE SCAN
function. Switches to Channel 16 between
each channel when scanning. For use in
Scandinavia only.
(1 – 16, 2 – 16, 3 – 16, 4 – 16).
Enables or disables confirmation key beep
from all first level functions. (NB. Second
level key beep cannot be disabled).
Selects channel to be displayed on power
up, usually Channel 16.
Selects alternate channel to be monitored
when DUAL WATCH selected.
Enables or disables USA weather
channels.
20