Simrad RD68 Service Manual page 13

for 35mm. Cut off the Blue wire flush with the outer insulation, (not
used). Cut back the Red wire to 20 mm long from the end of the outer
insulation, the Orange and Black wire to 30 mm and the Green and White
wire to 35 mm. Strip and tin the ends. Pass the end of the cable up
through the hole in the bottom of the front case, apply a small quantity of
Hellerman Sleeving Oil to the cable and slide on Cable Grommet
E03141. Pull the cable and grommet through together, until the grommet
is fully home into the case, ensuring that the flat on the head of the
grommet is facing out, not towards the wall of the case. Then pull cable
back through grommet by approximately 30mm. Wipe off any excess
sleeving oil from the cable. Secure with Cable Tie 200026. Fit the
handset weight E03311 and hold in place by fitting 3 Grommets 190024
onto the pillars. Solder the five wires and screen from the coiled cable
and the two wires from the speaker to the PCB E03309. Position the
PCB into the case on top of the three pillars retaining the weight and
using 3 Screws 200082, fix the PCB into the case. Fully tighten the 3
screws. Fit PTT Key and check that the key operates the switch. Into
the groove around the outside of the Rear Case E03140 fit Case Seal
E03142 ensuring it is pushed fully home. Fit the rear case onto the front,
ensuring the seal remains in place, using 6 Screws 200055 with washers
and tighten screws firmly to secure front and rear case halves together.
8