Chrysler 1991 Service Manual Supplement page 128

•
STEERING 11 - 3
PUMP SHAFT VACUUM
PUMP DRIVE
VACUUM PUMP
BRACKET
OIL FEED
FITTING
MOUNTING
BRACKET
J9119-69
Fig, 7 Steering Pump Removal/Installation
(8) Install the oil feed line to the vacuum pump
(Fig. 3). Tighten the oil line connection to 7 N-m (60
in. lbs./ 5 ft. lbs.) torque.
(9) Install the fluid hoses to the power steering
pump. Tighten the pressure fitting at the pump with
30 N-m (22 ft. lbs.) torque.
(10) Install and clamp the hose on the vacuum
pump.
TORQUE SPECIFICATIONS
J9119-71
Fig. 8 Steering/Vacuum Pump Assembly
(11) Fill the reservoir with power steering fluid
only. If necessary, refer to JPump Initial Operation
for detailed instructions.
(12) Start and run the engine. Check the operation
of the brakes, if necessary refer to Group 5—Brakes
for additional information.
COMPONENT SET-TO-TORQUE
RECHECK TORQUE
Vacuum/Steering Pump-to-Block (Diesel)
77 N*m (57 ft. lbs.)
Oil Pressure Feed Vacuum Pump (Diesel)
7 N*m (60 in. lbs.)
Pump-to-Bracket Attaching Bolt/Nut
24 N*m (18 in. lbs.)
Power Steering Gear Housing-to-Frame Bolt/Nut 136 N*m (100 ft. lbs.)
Sector Shaft Adjustment Screw Locknut (Power Steering Gear) 38 N*m (28 ft. lbs.)
Sector Shaft Cover Bolt (Power Steering Gear)
203 N-m (150 ft. lbs.)
High Pressure Hose Fitting (At Pump and Gear)
30 N*m (22 ft. lbs.)
Steering Wheel-to-Shaft Nut Non-Tilt or Tilt Column 61 N-m (45 ft. lbs.)
Steering Column Bracket-to-Support Stud Nut
2 N-m (20 in. lbs.)
Steering Column Bracket-to-instrument Panel Support Nut
12 N-m (110 in. lbs.)
Steering Column Shaft-to-Steering Gear Coupler Bolt 23 N*m (200 in. lbs.)
Steering Column Support Plate Bolt
7 N-m (60 in. lbs.)
J9119-72