Chrysler 1991 Service Manual Supplement page 10

BRAKES 5 - 3
(5) Remove oil pressure sender (Fig. 4).
PUMP ASSEMBLY
LOWER MOUNTING
STEERING
PUMP
ENGINE BLOCK
J9119-74
Fig. 4 Oil Pressure Sender Location
(6) Disconnect lubricating oil feed line from fitting
at underside of vacuum pump (Fig. 5).
VACUUM
PUMP
VACUUM
PUMP
OIL FEED
LINE J9105-96
Fig. S Oil Feed Line Connection At Pump
(7) Remove lower bolt that attaches pump assembly
to engine block (Fig. 6).
(8) Remove bottom, inboard nut that attaches
adapter to steering pump (Fig. 6). This nut secures a
small bracket to engine block. Nut and bracket must
be removed before pump assembly can be removed
from block.
ADAPTER
BRACKET
BOTTOM-INBOARD
ADAPTER BRACKET NUT
J9105-97
Fig. 6 Adapter And Pump Mounting Fastener
Location
(9) Remove upper bolt that attaches pump assem-
bly to engine block (Fig. 7).
(10) Remove pump assembly from vehicle (Fig. 8).
J9119-76
Fig. 7 Removing Pump Assembly Upper Mounting
Bolt
VACUUM PUMP REPLACEMENT
(1) Remove nuts attaching vacuum pump to
adapter (Fig. 8).