Entering And Editing Text; Entering Text From The Keyboard; Adding A New Line; Adding A New Block - Brother P-touch PT-E300M User Manual

• Press the Escape key to return to the previous step.
• Serialize mode can be also applied to bar codes. A bar code is counted as a character.
• Any symbols or other non-alphanumeric characters in the auto-numbering sequence are ignored.
• Serialize mode sequence can only contain a maximum of five characters.
• Letters and numbers increase as shown below:
0  1
A  B
a  b
A0  A1
Spaces (shown as underscores "_" in the example below) can be used to adjust the spacing
between characters or to control the number of digits that are printed.
_9  10
_Z  AA
1_9  2_0 ...9_9 0_0  ...

Entering Text from the Keyboard

• The keyboard of your P-touch labeling system can be used in the same way as a standard
computer keyboard.

Adding a New Line

• To end the current line of text and start a new line, press the Enter key. A return mark
appears at the end of the line and the cursor moves to the start of the new line.
• Maximum number of lines
- 0.70" (18 mm) tape: 5 lines
- 0.47" (12 mm) tape: 3 lines
- 0.35" (9 mm) and 0.23" (6 mm) tape: 2 lines
- 0.13" (3.5 mm) tape: 1 line
• If you press the Enter key when five lines already exist, an error message is displayed.
• When PUNCH-DOWN BLOCK is selected, you can enter up to 2 lines.

Adding a New Block

• When GENERAL is selected, you can create a new block up to 5. To create a new block
of text/lines to the right of your current text, press the Shift key and then press the Enter
key. The cursor moves to the start of the new block. In other labeling application types, you
can set the number of blocks when pressing a label application key. Some labeling
application types are not required.

Moving the Cursor

• Press the , ,
• To move the cursor to the beginning or end of the current line, press the Shift key and then
press the or key.
• To move the cursor to the beginning of previous or next block, press the Shift key and then
press the or

Inserting Text

• To insert additional text into an existing line of text, move the cursor to the character to the
right of the position where you want to start inserting text and then enter the additional text.
The new text is inserted to the left of the cursor.
...9  0  ...
...Z  A  ...
...z  a  ...
...A9  B0  ...
...99  00  ...
...ZZ  AA  ...

Entering and Editing Text

or key to move the cursor one space or line.
key.
1
2
3
4
5
6
7
8
9
34
Entering and Editing Text