Advertisement
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step.
*Some parts are pre-installed.
A.
Attach the end of Cable (43) to Hook (39). Link the hook onto the triangular plate hole under the
Mainframe Assembly (1).
B.
Attach Cable (43) around the three Pulleys (23) using:
Three 26 (M10 x 42 hex head bolt)
Six 35 (f10 washer)
Three 37 (M10 nylon lock nut)
C.
When setting up the long configuration, please use Cable (43).
D.
When setting up the short configuration, please use Cable (44).
8
Advertisement
