Troubleshooting - Siemens Gigaset 4210 User Manual

Gigaset 4015 Comfort, USA, A31008-G4015-B102-1-
Maintenance
Simply wipe the base station and handset with a damp cloth or an antistatic wipe.
use a dry cloth as this can cause static discharge.
Never Never
Never Never

Troubleshooting

If your telephone does not behave the way you want it to, first try to solve the problem
using the following list.
Fault
No display
No reaction to keystroke
No radio connection to the
base station – E.g. base sta-
tion 1 is flashing
Handset that is in the base
station is not charging
Handset does not ring
You cannot hear
The incoming call number is
not displayed although Cal-
ler ID is set.
The ringer/dialing tone
cannot be heard.
Error beep is generated (de-
scending tone sequence)
Possible cause
Handset not activated
Batteries empty
Keypad protection activated
Handset outside the base
station range
Handset not registered
Base station not activated
Line seized by a second
handset for a long period
Ringer off
F
The key was pressed –
the microphone is "muted"
The telephone number
transmission is blocked
You have changed the tele-
phone cord on your Gigaset.
Wrong input
anha.fm 25.06.0
Appendix
Solution
Hold down end call key
for 1 second
Charge or replace the batte-
ries (page 4)
ª
Hold down the key for
1 second
Move closer to the base sta-
tion
Register the handset
(page 39)
Check the connector at base
station (page 3)
Maximum charging power is
only possible while nobody
is making calls
Activate the ringer
«
Hold down the key
Î
Press , to activate the
microphone
The callers must permit the
transmission of their tele-
phone numbers at their net-
work provider
Ensure, when purchasing a
new cord, that it has the cor-
rect pin assignment (3-4 as-
signment of the telephone
leads/EURO CTR37).
Repeat the procedure; note
the display and, if necessary,
refer to the operating in-
structions
a
61