Cub Cadet 3000 Series Service Manual page 83

19. Remove both self tapping screws securing the
brake assembly to the transmission housing
using a 3/8" socket. See Figure 14.
Brake Assembly
Figure 14
20. Remove the brake assembly.
21. Remove the brake disc.
22. Remove the oil seal from the 9T output shaft.
23. Disassemble and inspect the brake assembly for
damage or wear. See Figure 15.
Hex Screw
Hex Nut
Brake
Yoke
Actuator Pins
Puck Plate
Brake Pad
Figure 15
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Cast Iron Transmission Disassembly
Self Tapping Screws
Anti-rotation Bracket
Flat Washer
Torsion Spring
Brake Actuator Arm
NOTE: Lubricate the actuator pins before reas-
sembling. See Figure 16.
Actuator Pins
Puck Plate
Brake Pad
24. Loosen and slide the hose clamp up the vent
tube using a large pair of pliers. See Figure 17.
Vent Tube
Hose Clamp
25. Remove the vent tube from the pipe fitting.
15A- 7
Figure 16
Figure 17