Table of Contents
Advertisement
OPERATION
RADIO OPERATION
◆
Switching to Radio Mode
Press MODE button on remote control
or MODE on the front panel start radio
mode.
The band/frequency/station/clock and
other information will display on the
display.
RADIO
87.50
BAND
:
STATION:
DISC
POP
◆
Selecting the Frequency Band
Press BND button on remote control or
BND/AMS on the front panel to select
desired band. The reception band will
change in the following order:
FM1 FM2 FM3 MW1/AM1 MW2/AM2
◆
Selecting Station
Press
/
buttons on the remote
control or press
/
panel shortly to adjust the frequency
manually.
Hold Press
/
on the remote
control or hold press
front panel for fast tuning. The
frequency is updated correspondingly
on display.
◆
Setting Memory
Press radio preset buttons (numeric
buttons 1~6) on remote control or on
the front panel to preset stations at
radio mode. Each band can store six
preset stations. The stations might be
FM1, FM2, FM3, MW1 (AM1) and
MW2 (AM2) band. The operation is as
below:
ST
MHZ
FM1
M1
on the front
/
on the
22
1) Store in Memory
Press and hold desired radio preset
buttons (numeric buttons 1~6) on the
remote control or on the front panel
for several seconds, the current
listening station will be stored into
the number button.
2) Retrieve a Preset Station
Press any one of the radio preset
buttons (numeric buttons 1~6) on the
remote control or on the front panel
to retrieve a station which had been
stored in the memory in advance and
the chosen frequency will be shown
on display.
◆ A
utomatic memory storing &
program scanning
1) Program scanning
Shortly
press
remote control to scan preset
station.
2) Automatic memory storing
Press and hold press AMS button
on remote control or BND/AMS
button on the front panel for about
several seconds, the radio searches
from the current frequency and
checks the signal strength until one
cycle search is finished. And then
stations are stored into the preset
number button in turn according to
the strength of the stations. When
auto search is finished, it will enter
into
preset
automatically.
Note: Press and hold 1-6 numeric
buttons on the remote control for
about several seconds, will store
the current station to the current
numeric key position.
button
on
AMS
scan
mode
Advertisement
Table of Contents
