Table of Contents
Advertisement
OPERATION
6) MASK DPI/ALL
Use the volume knob (3) to set
MASK DPI or MASK ALL.
Setting to mask station during
search:
DPI : Alternative frequencies with
different Pl code are excluded
from the search.
ALL : Alternative frequencies with
different Pl code and no RDS
information with high signal level
are excluded from the search.
LOUDNESS
Press BND/LOU/ENT button (7) for several
seconds to reinforce the bass output. Press
it for several seconds again to release this
function.
DISPLAY INFORMATION
Press DSP button (10) to operate as the
conversion of each display mode.
EQUALIZATION
Press
button
EQ
equalization function and to select desired
audio mode. There are five kinds of mode
as below:
→FLAT→CLASSICS→POP M→ROCK M→DSP OFF
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (25).
ESP FUNCTION
The unit can be shockproof about ten
seconds.
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the auxiliary input jack
(11) on the front panel. After finishing the
connection, you can press MOD button
(21) on the front panel to switch the mode
to AUX IN mode.
(12)
to
turn
on
RESET FUNCTION
Reset button (4) must be activated with
either a ballpoint pen or thin metal object.
The reset button is to be activated for the
following reasons:
-
Initial installation of the unit when all
wiring is completed.
-
All the function buttons do not operate.
-
Error symbol on the display.
Note: if press reset button (4), the unit can't
work yet, please use a cotton swab soaked
in isopropyl alcohol to clean the socket on
the front panel.
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MOD button (21) shortly to select
radio mode, the radio mode appears in the
display together with the memory band and
frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press BND/LOU/ENT
button (7) shortly to select the desired
band.
The reception band will change in the
following order:
FM1
FM2
SELECTING STATION
Press
button (26) or
shortly to activate automatic seek function.
Press for several seconds until "MANUAL"
appears on the display, the manual tuning
mode is selected. If both buttons have not
been pressed for several seconds, they will
return to seek tuning mode and "AUTO"
appears on the display.
AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
-
Automatic memory storing
Press AS/PS button (22) for several
seconds, the radio searches from the
current frequency and checks the signal
strength until one cycle search is
10
FM3
AM (MW)
button (27)
Advertisement
Table of Contents
