Cleaning The Screen And Cabinet…; Information - Toshiba Regza Z3030 Series Manual

Q
Q
Why does the GREEN Active Standby LED
sometimes take longer to go out?
A
When put into standby the television's active
standby will automatically search all available
channels for downloads, provided Auto upgrade is On.
The time it takes to do this may vary.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below .
LED indication
LED-2 LED-1
OFF Green (solid)
OFF Red (Solid)
Green Red
(solid) (solid) Active standby*
OFF Green
(solid)
Green Red
(solid) (solid)
OFF RED blinks Power protect
0.5 sec cycle
OFF Red blinks
1 sec cycle
OFF 2 times
flashing with
2 sec interval
* Digital only
** Analogue only
Cleaning the screen and cabinet...
Turn off the power, clean the screen and cabinet with a soft, dry cloth. We recommend that you do not use any proprietary polishes or
solvents on the screen or cabinet as this may cause damage.
Disposal...
The following information is only for EU-member states:
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about
recycling of this product, please contact your local city office, your household waste disposal service or the shop where
you purchased the product.
uestions
Condition Solution
The TV is
operating
properly
Standby with
Power-On
Mode set to
Sleep timer*
On timer**
detection
Turn OFF the TV
Abnormal
and unplug the
operation of
power cord. Plug
BUS line
the power cord
Abnormal
back in again and
operation
turn ON the TV.
(initialisation
error)
A
nswers
and
Q
Why are the colours wrong when an NTSC
source is played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
Set the Colour to Auto. and exit.
1
Go to the Picture settings menu and adjust
2
the tint.
Q
Why doesn't REGZA-LINK work?
A
If settings on connected REGZA-LINK equipment
are changed the equipment may fail to work
correctly with television. Removing the HDMI cable then
replacing it may help. If not turn off the television, remove
the power cable from the wall socket, then plug the
television back in and switch on.
Q
Why is there no sound or picture when in
HDMI mode?
A
Some early HDMI equipment may not work
properly with the latest HDMI television products,
due to new standard adoption. Try setting Lip Sync
Latency to Off.
43
continued
Manual setting
Colour system: Auto.
EXT2 A V C R
Store
OK
Back Watch TV
MENU EXIT