Input Signal Selection; Input Selection And Av Connections - Toshiba Regza Z3030 Series Manual

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 7
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
B until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g. 2S (EXT 2S), indicates the
B
input is set for an S-Video signal.
Input selection
At any time by pressing
1
screen showing modes and all stored external
equipment. Use and
e
select.
DTV
1
B
B 2
3
B
HDMI1
HDMI2
HDMI3
PC
ATV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be
selected. To switch between DTV and ATV press
the A/D button.
HDMI™ displays equipment connected to Input
HDMI on the back of the television.
PC displays a computer connected to Input
RGB/PC on the back of the television.
Input selection and
AV connections
B
a list will appear on
to highlight and OK to
f
DTV
1
B
B 2
3
B
HDMI1
HDMI2
HDMI3
PC
ATV

INPUT signal selection

This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
1
AV connection is highlighted, then press OK.
Language
Country
Auto tuning
Manual tuning
Antenna Amplifier
AV connection
Back
MENU
With or
z
2
required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
HDMI setting
EXT1 output
EXT2 input
EXT2 output
Back
MENU
If the colour is missing try the alternative setting.
37
until
e
SET UP
English
UK
OK
OK
On
OK
Watch TV
EXIT
select either AV or S-VIDEO as the
x
AV connection
PC
Digital
DTV
AV
DTV
Watch TV
EXIT
1/2