Programming Using The Base Unit (Kx-Tgp550 Only); Programmable Settings - Panasonic KX-TGP500 User Manual

:

Programming using the Base Unit (KX-TGP550 only)

Programmable settings

You can customise the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 34)
– using the direct commands (page 35)
Some of the features can be programmed through the Web user interface (page 41).
L Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
{MENU} (middle soft key)
2
Press {^}, {V}, {<}, or {>} to select the desired main menu. i {SELECT}
3
Press {V} or {^} to select the desired item in sub-menu 1. i {SELECT}
L In some cases, you may need to select from sub-menu 2. i {SELECT}
4
Press {V} or {^} to select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT}.
Note:
L See page 35 for the default settings.
L In the following table, ( ) indicates lines you need to select for the settings.
Main menu
Line Status
m
IP Service
Ringer Setup
(
34
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Sub-menu 1
–
Network Setting
Call Features
Ringer Volume
Ringtone
Interrupt tone
Document Version 2010-08
Sub-menu 2
–
*1
DHCP
*1
IP Settings
Embedded Web
Call Forward
(Line 1: 8 max.)
*1
– Unconditional
*1
– Busy
*1
– No Answer
*1
Do Not Disturb
(Line 1: 8 max.)
*1
Block Anonymous
(Line 1: 8 max.)
*1
Block Caller ID
(Line 1: 8 max.)
–
(Line 1: 8 max.)
–
Page
11
–
–
41
37
38
38
39
18
–
–