Appendix E. Io Box Installation - Win4NET H.264 8-Channel Mobile DVR User Manual

Appendix E. IO Box Installation

1. Cautions on Installation
Inside IO Box G-Sensor included. Mind following installation guide when install.
-
No matter where you install, maintain level with your vehicle.
-
Install parallelize with vehicle moving direction and X, Y, Z axis on product case.
-
Check moving direction and axis and set DIP switch on front properly.
Ex) If installed following picture
Rear
Set DIP switch as "Y-" as following picture.
2. Cautions.
Maintaining Level and Dip switch setup should be done before power input to device because
IO box calibrates G-sensor when system initialized. If not maintained level nor wrong dip switch
setup, system may fail to G-Sensor calibration. If failed to calibrate, G-Sensor output value would
not be adjusted again and it send sensor output data from IO box to main unit.
98
X Y Z +
OFF
ON
1 2 3 4
ON
_
Front