Win4NET H.264 8-Channel Mobile DVR User Manual page 15

Reset/SD Card Slot
• Reset: Back to factory setup value of DVR. To reset system, Press hold reset button with sharp
pin and power on. Hold reset button until booting process is over.
• SD Card Slot : SD Card is available as storage. If no HDD valid, system records data on SD
card.
LED Display
display DVR power and working status
:
LED doesn't flicker even temperature goes down during operation. Internal Heater working
when system turns on the temperatures below -20℃ and LED is on after heating up system.
When power goes out, system displays 'shut down' message and system goes off after
discharging internal capacitor.
: HDD access status
: GPS signal received and position fix status
: Lights on when use SD Card as recording device
: Shutdown delay status. Performs this process by system setup time when ACC power is
off but Main is on.
: LED is on when there is no available HDD, SD Card
: Network access status
: Alarm Status.
Lock Key Switch
Use this key lock when add or remove HDD on HDD rack. To remove HDD during
system is working, unlock it and check system shutdown message first and then
remove HDD rack.
14