Turning On The System; Status Bar; Osd Icons - Win4NET H.264 8-Channel Mobile DVR User Manual

1-2. Turning on the System

Once DVR is installed properly on vehicle, power is on when user turn the vehicle on. It takes
20-30sec. in initializing
Heating sensor activates when temperature is below -0°C (32°F) until it reaches HDD working
temperature. If SD card installed, system records on SD card first until HDD reaches on
working temperature and it switches recording to HDD automatically.
Recording stops when you turn off engine. This mobile dvr only working during the engine is
on.
Notice
: Removable HDD can be connected on your PC HDD after you remove from HDD rack. To
remove HDD from its rack, turn off system safely first and remove. Even system is operating
you can remove HDD after remove front cover. Once front cover removed, system will shut
down automatically and then you can remove HDD.
Note
: HDD should be formatted when it is installed first time.
"MENU > RECORD > Storage > HDD format"

1-3. Status Bar

Menu bar will appear bottom of screen as follows.

1-4. OSD Icons

No Recording
Recording (Red)
E.REC (Emergency Recording)
Press Menu to open main menu list.
Show used space as % of HDD being used.
Turned on when the HDD is set as overwritten.
Turned on when GPS data receiving
Turned on when the system is connected to network.
Turned on when Alarm is on active.
Turned on when when G-Sensor is on active
Emergency Recording mode.
Display Time & Date information
Turned on when IR remote controller is on active
23