Setting The Rinse Aid Dosage - Miele HG06 Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a recommen‐
ded setting of approx. 3 ml at the facto‐
ry.
If the function to adjust the Sensor
wash programme has been activated,
the amount of rinse aid dispensed in
the Sensor wash programme can be
higher than that set.
If spots appear on crockery and glass‐
ware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
 Decrease the rinse aid dosage.
Before using for the first time
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector button
 in, and whilst holding it in switch
the dishwasher on using the  but‐
ton.
Keep the programme selector button
 pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the Short button 3 times.
The Short indicator will flash rapidly 3
times at intervals.
The dosage set will show in the display
after the  symbol.
The factory default setting of   will
appear in the display.
This indicates a setting of 3 ml.
 Use the programme selector button
 to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.
27