Care and maintenance
10
Care and maintenance
10
Care and maintenance intervals
.01
10
Cleaning
.02
●
●
●
●
30
Cleaning ........................................................... daily, in continuous operation several times
General oiling .................................................................................................. twice a week
Oil the hook.....................................................................daily, before putting into operation
Oil needle-head parts ...................................................................................... twice a week
Lubricate the bevel gears.....................................................................................once a yea
Lubricate the top-feed drive eccentric .................................................................... Annually
Check/adjust air pressure................................................daily, before putting into operation
Check water bowl of air filter/regulator ...........................daily, before putting into operation
The maintenance intervals in the table refer to the average machine running
time in single-shift operation. If the machine running time is longer than this, it
is advisable to shorten these intervals.
2
7
6
5
Fig. 10 - 01
Take out bobbin case and clean hook race with petroleum spirit.
When inserting the bobbin case, make sure that the lug on the rear side of bobbin case
position stop 2 enters into groove 7.
Screw on hook gib 4.
Insert bobbin case and close cylinder-bed cap 1.
Do not run the machine without cylinder-bed cap 1!
Danger of injury by rotating hook!
Cleaning the hook area
Clean hook area with a brush daily, in
●
4
continuous operation several times daily.
Cleaning the hook
Open cylinder-bed cap 1.
●
Set needle bar at its highest position.
3
●
Remove top of bobbin case together
●
with bobbin
Unscrew and remove bobin case positi-
●
on stop 2.
Remove screw 3 and take off hook gib 4.
1
●
Turn balance wheel until point 5 is alig-
●
ned with point 6.
Switch off the machine!
Danger of injury due to uninten-
tional starting of the machine!