Stamina 55-6100U Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 12, 13, 14 & 15
R
STEP 12:
Unfold the Bench as follows:
Attach the BENCH BASE(32) to the Frame Assembly with the SECURING KNOB(41).
1.
Raise the Bench to the unfolded position. It may be necessary to hold the BENCH BASE(32) down with
2.
your toe.
Lock the Bench in its unfolded position by inserting the LOCKING PIN(37) into the hole in the SUPPORT
3.
TUBE(35).
STEP 13:
There is a "R" decal on the RIGHT ARM FRAME(45), and a "L" decal on the LEFT ARM
FRAME(46). Attach the ROTATING ARM ASSEMBLIES onto the BENCH FRAME(31) by inserting the
ARM FRAMES(45, 46) into both sides of the BENCH FRAME(31) and securing with HEX BOLTS
(M8 x 16mm)(82) and WASHERS(M8)(93).
STEP 14:
Remove the M8 nuts from the CARRIAGE BOLTS(M8 x 60)(77) on the ARM FRAMES
(45, 46) and install the LOCKING KNOBS(66) as shown. The M8 nuts are for shipping purposes only, they
may be discarded. Install ADJUSTMENT KNOBS(53) in ADJUSTMENT BLOCKS(52) as shown.
STEP 15:
The PILLOW(73) and BACK CUSHION(72) are the optional accessories that can be used
with the BENCH for various exercises. Attach the BACK CUSHION(72) onto the BENCH FRAME(31) by
inserting the BACK CUSHION SUPPORT(71) into both sides of the BENCH FRAME(31).
STEP 16:
The product will need a minimum floor space of 3.0m x 2.0m to use the product safely.
Remove
The M8 Nut
9
L
Remove
The M8 Nut