Stamina 55-6100U Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
NOTE: There is a "L" decal on the LEFT BASE(5), and a "R" decal on the RIGHT BASE(4) to help you
identify their positions on the frame.
STEP 4:
Place the BENCH upright in the folded position as shown above. Attach the RIGHT BASE(4)
onto the LOWER UPRIGHT(1) with CARRIAGE BOLTS(M8 x 65mm)(78) and NYLOCK NUTS(M8)(90).
Do not tighten until STEP 6.
STEP 5:
Insert the round tube on the BENCH BASE(32) into the holes on the RIGHT and LEFT
BASES(4, 5), then attach the LEFT BASE(5) onto the LOWER UPRIGHT(1) with CARRIAGE BOLTS
(M8 x 65mm)(78) and NYLOCK NUTS(M8)(90). Do not tighten until STEP 6.
STEP 6:
Slide the CROSS BAR(6) under the RIGHT and LEFT BASES(4, 5) and attach the CROSS
BAR(6) to the BENCH BASE(32) with the SECURING KNOB(41). Lay the FRAME ASSEMBLY on the
floor as shown in the illustration above. Attach the CROSS BAR(6) to the RIGHT and LEFT BASES(4, 5)
with BUTTON HEAD BOLTS(M8 x 16mm)(88). Stand the FRAME ASSEMBLY upright. Tighten NYLOCK
NUTS(90) in STEPS 4 and 5. Adjust the ENDCAPS(13) and LEVELING CAPS(14) so that the FRAME
ASSEMBLY sets flat on the floor.
STEP 7:
Attach the WHEEL SUPPORT(10) onto the LOWER UPRIGHT(1) with HEX BOLT(M8 x 40mm)
(83) and NYLOCK NUT(M8)(90).
STEP 6
R
7
STEP 4, 5 & 7
L