Advertisement
Before You Begin
To use a Verizon Wireless Network Extender you need:
• An always-on broadband Internet connection with a minimum speed of 1 MB (3.1 Mbps to support the maximum
EVDO data rate.)
• An available Ethernet port on either your broadband modem or a router connected to the
modem.
• If you are deploying a cluster of Network Extenders and/or your local network uses VLAN and/or static IP
addressing, refer to the user guide located at: www.verizonwireless.com/networkextender/business.
NOTE: If you are connecting your Network Extender to a router, please ensure that it supports Virtual Private Networking (VPN). Most routers support this
functionality, but if you are unsure of your router's capabilities, refer to the manual that came with your router.
Your Network Extender package should contain the components shown below:
Network
Extender
GPS Antenna
Ethernet Cable
Power Cord
Cable
NOTE: Contact Customer Care if a component is missing.
Combo_QSG_6x4in_V0_R1.indd 2
GPS
Antenna
Power
LED
System
LED
GPS LED
Power
WAN LED
Supply
GPS
Adjustable
Antenna
Antenna
Port
Heat
Vents
DC12V
Power
Port
WAN
Port
Connecting Your Network Extender
1. Place the Network Extender near a window in a central location. For best results, place the Network
Extender in an elevated location, such as the top of a bookshelf or tall cabinet. If you use a Wi-Fi router, keep
the Network Extender at least two feet away from it.
2. Connect one end of the included Ethernet cable to an open port on the router (1) and connect the other end
to the WAN port located at the rear of the Network Extender (2).
3. Plug the power supply connector into the DC 12V power port located at the rear of the Network Extender
(3).
4. Insert one end of the power cord into the power supply and then plug the other end into an available outlet
(4).
8/2/2012 9:38:42 AM
Advertisement
