Introduction; Navigating Setup; Invoking Setup - Symbol PDT 7500 Series Product Reference Manual

Introduction

The PDT 7500 Series terminal has a system setup program which allows you to configure
many of the terminal's basic characteristics. Specifically, the setup program is made up of five
screens and defines:
contrast value
!
backlight
!
beeper volume
!
beeper frequency
!
suspend time
!
backlight time
!
cold boot time
!
enable
!
system date and time.
!
Setup also displays the RAM and Flash sizes. This section takes you through the setup
program, enabling you to set each of these default values.

Navigating Setup

To scroll through the five setup screens, press the left and right arrow keys on the terminal's
keypad. To scroll through the values in each field, press the (+) and (-) keys on the terminal's
keypad. To scroll up and down on any of the screens, press the up and down arrow keys on
the terminal's keypad.

Invoking Setup

To invoke the setup application:
1. Start the terminal by performing a cold boot (press the power button and the trigger
button simultaneously until the terminal reboots).
While the terminal is booting, a message displays on the bottom of the screen, "Hold
Trig for Setup".
Terminal Configuration: Setup
8-3