WARNING
The belt locks and the belts must be in their original position after folding
■
back the seat cushions and backrests - they must be ready to use.
The seat backrests must be securely interlocked in position so that no ob-
■
jects in the boot can slide forwards if there is sudden braking - risk of injury!
Ensure that the rear seat backrests are properly engaged. It is only then that
■
the three-point seat belt for the middle seat can reliably fulfil its function.
Ensure that the cross rod is inserted into the mounts
■
page 80 or
» Fig. 79
on page 80 in the front position!
Using the net partition behind the rear seats
ä
First read and observe the introductory information and safety warn-
ings
on page 79.
Pulling out
›
Pull the net partition by the bracket
tion of the holders
.
C
›
Insert the cross rod into one of the mounts
›
In the same way, insert the cross rod into the mount
vehicle.
Folding
›
First pull the cross rod back slightly on the one side and then on the other side
and remove it from the mounts
C
›
Hold the cross rod in such a way that the net partition can slowly roll up into
the housing
without being damaged.
B
If you wish to use the entire boot, the foldable boot cover can be re-
moved
» Fig. 69
on page 76.
80
Using the system
» Fig. 78
on
C
Fig. 78
Pull out the net partition
A
» Fig. 78
out of the housing
B
and push forwards.
C
on the other side of the
C
» Fig.
78.
Using the net partition behind the front seats
Ð
ä
First read and observe the introductory information and safety warn-
ings
on page 79.
Pulling out
›
Fold the rear seats forward
›
Pull the net partition by the bracket
›
First of all insert the cross rod into the mount
ward.
›
In the same way, insert the cross rod into the mount
vehicle.
Folding
›
First pull the cross rod back slightly on the one side and then on the other side
and remove it from the mounts
›
Hold the cross rod in such a way that the net partition can slowly roll up into
the housing
without being damaged.
B
›
Fold the rear seats back into their original position.
in direc-
Ð
Fig. 79
Pull out the net partition
» page
71.
» Fig. 79
out of the housing
A
on one side and push it for-
C
on the other side of the
C
» Fig.
79.
C
.
B
Ð