Skoda Superb Owner's Manual page 80

The variable loading floor can be partially pulled out over the rear bumper. The
variable loading floor which is pulled out in such a way is solely used as a seat, for
example for changing shoes. When pulling out the variable loading floor, the front
edge (close to the rear seats) is lifted at the same time. Thus, small objects can no
longer fall into the space between the boot floor and the variable loading floor.
›
Grasp the rear part of the variable loading floor by the handle, raise it slightly in
the direction of the arrow » Fig. 72
1
rection of the arrow until it engages in the opening
2
›
To push the variable loading floor back into place, grasp the part of the floor by
the handle, raise it slightly in the direction of the arrow
up to the stop.
CAUTION
Ensure that the raised front edge of the variable loading floor is not damaged.
Dividing the boot with variable loading floor
The boot can be divided with the variable loading floor.
›
Grasp the rear part of the floor by the handle, raise it in direction of arrow
» Fig. 72 on page 77 and insert the rear edge in one of the openings
1
» Fig. 73.
A
The variable loading floor is secured in the openings
The variable loading floor can be pulled out a little more before dividing the boot
with the variable loading floor » page
rear seats and the separation.
CAUTION
Ensure that the raised front edge of the variable loading floor is not damaged.
78
Using the system
and pull it out over the bumper in the di-
» Fig. 72.
C
and push it forwards
1
Fig. 73
Dividing the boot
against movement.
A
77. This enlarges the space between the
Removing and installing the variable loading floor
Fig. 74 Boot: Fold up variable loading floor
Ð
Fig. 75 Boot: remove variable loading floor
The variable loading floor can be removed and reinstalled, if necessary.
Removing
›
Grasp the rear part of the floor by the handle, raise it slightly in the direction of
the arrow » Fig. 74 and pull it out over the bumper in the direction of the
1
arrow until it engages in the opening
2
›
Fold up the loading floor by moving it in the direction of the arrow
›
Press the safety buttons
A
Install
›
Fold up the floor and place it on the carrier rails.
›
Push the floor forwards until it engages in the openings
rails » Fig. 75.
Ð
» Fig. 75.
C
» Fig. 75 and remove the floor.
in the carrier
B
» Fig. 74.
3
£