Skoda Superb Owner's Manual page 208

Rear towing eye
Fig. 182 Rear bumper: Removing the cap/installing the towing eye
ä
First read and observe the introductory information and safety warn-
ings on page 204.
›
Press onto the bottom part of the cap in the rear bumper
move it.
›
Screw in the towing eye by turning to the left up to the stop
tighten as much as possible. For tightening purposes, we recommend, for exam-
ple, using the wheel wrench, towing eye from another vehicle or a similar object
that can be pushed through the eye.
›
After unscrewing the towing eye, put the cap on and press into place. The cap
must engage firmly.
On vehicles with a factory-fitted towing device, there is no mount for the screw-
in towing eye behind the cap » page
CAUTION
The towing eye must always be screwed in fully and firmly tightened, otherwise
the towing eye can tear when towing in or tow-starting.
Vehicles a towing device
ä
First read and observe the introductory information and safety warn-
ings on page 204.
On vehicles with a factory-fitted towing device, there is no mount for the screw-
in towing eye behind the cap.
206
Do-it-yourself
» Fig. 182 -  and re-
» Fig. 182
206, Vehicles a towing device.
Use the detachable ball rod for towing. For installing the detachable ball rod, see
the instructions manual for the towing device.
Towing the vehicle using the towing device is a viable alternative solution to us-
ing the towing eye.
If the towing device is removed completely, it must be replaced with the standard
reinforcement of the rear bumper which is part of the mount for the towing eye.
If this procedure is not observed, the vehicle may not meet the national legal pro-
visions.
CAUTION
The detachable ball rod and the vehicle can be damaged if an unsuitable tow bar
is used.
Note
The detachable ball rod must always be in the vehicle so that it can be used for
towing, if necessary.
-  and
Ð
Ð