Skoda Superb Owner's Manual page 46

CAUTION
During the winter it may be necessary to remove any ice and snow in the vicinity
of the sliding/tilting roof before opening it to prevent any damage to the opening
mechanism and seal.
Convenience operation
An open sliding/tilting roof can also be closed from the outside.
›
Press and hold the lock button

the locking cylinder of the driver's door in the lock position, or with the KESSY
system, keep your finger on the sensor
The closing operation stops immediately when you release the key or the lock
button.
WARNING
Close the sliding/tilting roof carefully - risk of injury! The force limiter does not
operate with the convenience closing.
Electric sliding/tilting roof with solar cells
If there is sufficient bright sunlight, the solar cells on the sliding/tilting roof deliv-
er power for the fresh air blower. Further information
(automatic air conditioning system).
The operation of the sliding/tilting roof with solar cells is the same as of a normal
sliding/tilting roof.
44
Using the system
on the remote control key or hold the key in
» Fig. 13 on page 32 » .
1
» page 97, Climatronic
Emergency operation
Ð
Fig. 26 Point for positioning screwdriver/opening for positioning the key
The sliding/tilting roof can be closed or opened manually if the system is faulty.
The emergency operation of the sliding roof is located underneath the glasses
storage box » page 87, Glasses storage box.
1
›
Open the glasses storage box.
›
Carefully insert an approximately 5 mm wide screwdriver into the slot in the po-
Ð
sitions shown by the arrows
›
Carefully fold the glasses storage box downwards by gently pressing down and
turning the screwdriver.
›
Insert an Allen key, SW 4, up to the stop into the opening
the sliding/tilting roof.
›
Reinstall the glasses storage box by first inserting the plastic plugs and then
pushing the entire part upwards.
Have the fault rectified by a ŠKODA specialist garage.
Ð
Note
It is necessary after each emergency operation (using the Allen key) to move the
sliding/tilting roof into the basic position. This is why the rotary switch must be
set to the switch position » Fig. 25
A
10 seconds.
» Fig. 26.
1
and close or open
2
on page 43 and pressed forward for about
Ð