Table of Contents
Advertisement
9 ACCESS TO COMPONENTS
9.1 Work-top
a. Remove the two rear screws (1), push the work-top towards the rear of
the appliance and detach.
9.1.1
Pressure switch
a. Remove the work-top
b. Detach the wiring connectors
c. Press the anchor tabs (2) and pull towards the rear
d. Detach the pressure switch tube
e. To remove the second pressure switch (if featured, this is inside the
cross-member), press the anchor tabs and push towards the front
panel.
9.1.2
Suppressor/motor capacitor
a. Remove the work-top.
b. Detach the wiring support from the cross-member and move
downwards (3).
c. Remove the suppressor/capacitor from its housing in the cross-member
d. Detach the wiring connectors.
9.1.3
Solenoid valve (version fitted to the cabinet)
a. Remove the work-top
b. Unscrew the water fill hose from the solenoid valve
c. Detach the wiring connector.
d. Detach the solenoid valve from the support (4)
e. Remove the hose clamp and detach the solenoid valve from the hose
9.1.4
Solenoid valve (version fitted to detergent dispenser)
a. Remove the work-top
b. Unscrew the water fill hose from the extension/solenoid valve
c. Lift the rear cable clamp block and detach from the extension/solenoid
valve (5)
d. Remove the screw and detach the solenoid valve support bracket from
the detergent dispenser (6)
e. Extract the solenoid valve/extension assembly from the detergent
dispenser (7)
f.
Detach the wiring connector
g. Unscrew the solenoid valve from the extension.
When re-assembling:
The seal between the solenoid valve and the detergent dispenser should
be inserted before the solenoid valve and lubricated with soapy water or
silicone oil to facilitate insertion.
SOI/DT 2002-05 eb
97
599 35 23-17
Advertisement
Table of Contents
