Table of Contents
Advertisement
7.3 Drying condenser
The drying condenser consists of a plastic structure which is connected to the lower section of the tub by a
rubber sleeve, and to the fan by a seal. The condenser is attached to the base of the appliance.
The humid air enters from the lower section of the condenser, while a jet of cold water is introduced from the
upper section. The shape of the condenser is such as to create a turbulence between the flow of humid air
and the jet of cold water. This condenses the humidity contained in the air. Therefore, the fan receives cold,
dry air, which is then re-circulated and again heated. The cooling water and the condensation run down to
the bottom of the tub, to be discharged by the drain pump.
Type "A" condenser
1. Solenoid valve
2. Tube from solenoid valve to
coupling
3. Coupling
4. Steam venting tube (washing)
5. Tube from detergent dispenser
to tub
6. Condensed water fill hose
7. Drying condenser
SOI/DT 2002-05 eb
Type "B" condenser
1. Solenoid valve
2. Tube from solenoid valve to
coupling
3. Coupling
4. Condensed water fill hose and
steam vent (washing)
5. Tube from detergent dispenser
to tub
7. Drying condenser
57
599 35 23-17
Advertisement
Table of Contents
