Manufacturer’s Regulatory Declarations - Silicon Graphics O2 Installation Instructions Manual

Manufacturer's Regulatory Declarations
Class B
Caution: This device has several governmental and third-party approvals, licenses, and
permits. Do not modify this product in any way that is not expressly approved by Silicon
Graphics. If you do, you may lose these approvals and your governmental agency
authority to operate this device.
The device conforms to several national and international specifications and European
Directives listed on the Manufacturer's Declaration of Conformity. The CE insignia
displayed on each device is an indication of conformity to the European requirements.
FCC Declaration of Conformance
Trade Name
Product
Model Number
Date of Conformance
Responsible Party
Address
Telephone
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
Silicon Graphics, Inc.
External Hard Disk Drive
CMNB019B
10/98
Silicon Graphics, Inc.
2011 North Shoreline Boulevard,
Mountain View, California 94043-1389
(650) 933-1071
Manufacturer's Regulatory Declarations
3