Rapid Reading Of Alarm Codes With Lcd; Cancelling The Last Alarm With Lcd - Electrolux WASHING MACHINES Service Manual

13.3 Rapid reading of alarm codes with LCD

The last alarm code can be displayed even if the programme selector is not in the tenth position
(diagnostics) or if the appliance is in normal operating mode (e.g. during the execution of the washing
programme):
Five minutes after the switching on, press and hold down the START/PAUSE and EXIT buttons for 2
seconds, the LCD displaying shows the last alarm codes (of the main board and display board). The
displaying of the alarms depends on the time in which the buttons are hold down.
During the time the alarm is displayed, the appliance continues to perform the cycle or, if it is in the
selection phase, it keeps in memory the options previously chosen.

13.4 Cancelling the last alarm with LCD

It is good practice to cancel the last alarm, after reading the alarm code to check whether the alarm re-
occurs during the diagnostics control after the reparation of the appliance.
1. Select diagnostics mode and turn the
programme selector to the tenth position
(reading of alarm)
2. Press simultaneously START/PAUSE button
and button 5 (nearest option to START/PAUSE
button).
3. Hold down the START/PAUSE and 5 button
until the alarms are cancelled.
SOI/DT 2005-01 dmm
57/67
599 36 82-57