Service Know-How - JVC GR-DVP7U Service Manual

Hide thumbs Also See for GR-DVP7U:

Table of Contents

1.8 SERVICE KNOW-HOW

When performing disassembly/assembly work to this model,

the parts that are most complicated and require special at-

tention are the E. VF unit and the OP MDA board, OP block

and shoe assemblies, all of which are mounted inside the

lower case assembly.

Care should be taken in handling these parts as they are

mounted inside the lower case assembly (except the E.VF

unit) and there is a lack of adequate space to work conven-

iently. This section gives further details regarding the disas-

sembly procedures, although they have been described in

previous sections.

NOTE

OP MDA

PWB

Fig. 1-8-1

1. See Fig. 1-8-1.

(1) While moving the ! microphone out of way, remove the

screw (39) and take out the @ OP block assembly.

(2) Remove two screws (40, 41) and open the $ OP MDA

board assembly.

(3) Remove two screws (42, 43) to disconnect the connec-

tor (CN203), then take out the FPC to remove the # E.

VF unit.

Note #a : Be careful not to damage the FPC or the switches

when carrying out this work.

NOTE

)

1-12

Table of Contents