Table of Contents
Advertisement
Replacing Water Inlet
NOTE: It is not necessary to remove the disposer to repair water
inlet.
Water Inlet Kit part number is
1.
Using a wrench, remove water inlet from upper body (Figure
10).
2.
Remove any burrs on water inlet hole.
3.
Wrap Teflon tape around new water inlet fitting and insert
fitting through water inlet hole from inside of upper body.
4.
Place O-ring in groove in water inlet nut. A small amount of
grease may be used to hold O-ring in place during installa-
tion.
5.
From outside of body, attach water inlet nut to water inlet fit-
ting. Tighten nut with wrench.
NOTE: Water inlet fitting and nut are joined with a left-hand thread.
Replacing Shredder Gasket
1.
Remove disposer. See "Removing Disposer" on page 7.
2.
Remove screws securing tailpipe and gasket from upper end
bell assembly (Figure 10).
3.
Remove terminal box and trim band (Figure 10).
4.
Remove screws securing body and cover assembly to upper
end bell assembly (Figure 10).
5.
Lift cover and upper body assembly off upper end bell
assembly
6.
Separate the upper body assembly from the cover.
7.
Remove old gasket. Install new gasket to bottom edge of up-
per body (Figure 11).
8.
Place cover over upper body.
9.
Place cover and upper body assembly onto upper end bell
assembly. There are two tabs on the inside of the cover.
These tabs fit into the two side grooves on the upper end bell
with the waste outlet aligned with the waste outlet cutout.
10. Secure in place with screws.
11. Install trim band and terminal box. See "Terminal Box & Trim
Band" on page 9.
12. Re-install tailpipe gasket and tailpipe using screws (Figure
10).
13. Install disposer. See "Installing Disposer" on page 7.
10
GRINDING CHAMBER
13956.
Commercial Disposers
Figure 10. Cover and Upper Body Assembly
Figure 11. Replacing Shredder Gasket
Service Manual
Hide quick links:
Advertisement
Table of Contents
