After Use - Fakir Deluxe 9800 S ÖKO Power User Manual

C- Place the carpet spray extraction nozzle
on the floor, pull the lever of the metering
valve and move the nozzle blowly to the
rear across the carpet at the same time.
In this way the cleaning solution is sprayed
under pressure onto the dirty area and
is immediately sucked up again together with the dirt.
To move the nozzle in a forward direction, release the
valve lever and lift the nozzle clear of the carpet. The
entire area is covered by cleaning adjacent strips.
Note: If, temporarily no spray extraction liquid is
needed; switch off the pump.
D- Float Valve - When the liquid in the
tank reaches the maximum level, the
float valve will automatically close the
intake aperture in the hood, interrupting
the intake process. Switch the appliance
off immediately and withdraw the mains
plug. Now carry or pull the complete appliance to the
disposal point, remove the connection hose from the
spray extraction liquid tank and the pressure hose from
the hood, then empty the canister.
Cleaning Tiled Floors
E- Tiled floor cleaning attachement for
carpet spray extraction nozzle. Push the
attachement onto the carpet spray
extraction nozzle, then proceed as
described under "spray extraction of
carpeted floors" above.
F- The tiled floor cleaning attachement
can simply be pulled off when no longer
required.
Cleaning Upholstery
G- The upholstery cleaning nozzle is
supplied for the purpose of cleaning
upholstery, car seats etc. To seperate the
connection, turn the bayonet fitting in
the opposite direction and pull off.
H- Now proceed as following:
• Set the control switch to maximum
suction power.
• Switch t on the appliance by light
pressure on the ON/OFF switch.
• Start the pump by applying light
pressure to the switch.
04
I- Place the upholstery cleaning nozzle
lightly on the upholstery, pull the button
of handle, moving the nozzle slowly
backwards at the same time. In this way
the cleaning solution is sprayed under
pressure onto the dirty area and is
immediately sucked up again together with the dirt. The
entire area is covered by cleaning adjacent strips.
Note: If, temporarily no spray extraction liquid is
needed; switch off the pump.
J- Float Valve - When the liquid in the
tank reaches the maximum level, the float
valve will automatically close the intake
aperture in the hood, interrupting the
intake process. Switch the appliance off
immediately and withdraw the mains
plug. Now carry or pull the complete
appliance to the disposal point, remove
the connection hose from the spray
extraction liquid tank and the pressure
hose from the hood, then empty the
canister. To empty the liquid from the tank, turn off the
motor switch and open the water discharge. Before
switching it on again verify the water discharge is closed.
ATTENTION!!! When the machine is working, never
open the water discharge.

After Use

A- Switch off the appliance, withdraw
the mains plug.
B- Remove the hood and empty the
canister and cleaning liquid tank. To
empty the liquid from the tank, turn off
the motor switch and open the water
discharge. Before switching it on again
verify the water discharge is closed.
ATTENTION!!! When the machine is working never
open water discharge.