M3 Mobile MC-6200S User Manual page 113

113
When M3 is not turned
on even if it is connected
to the charger.
Automatic turn-off
Automatic idle mode
or LCD backlight turn-
off
When you lost the
password
Display owner
information
Too small volume or
no sound
If M3‟s program memory is not sufficient, it can slow down
the speed. Click Go to Start> Settings> Control Penal>
System, then expand the program memory area with the
slider in the memory tab. If storage memory area occupies
too much space, backup programs in the storage area to PC
so as to empty the space. Then expand the program
memory area.
When the battery is completely discharged, the power of M3
can be turned off automatically. In that case, charge the
battery for about 30 minutes and turn it on. Then keep on
charging the battery.
When the battery cannot be charged, check out the
connection state between the charger and M3.
battery is properly on charge, the lamp on the charger turns
out red. When the battery is fully charged, it turns to green.
If you overuse M3 when it is discharged, it may cause
damage to the device, Before trying to use M3, be sure to
charge the battery again.
When battery capacity is too low, the power of M3 will
automatically go off. For detailed information, refer to the
problem solving regarding battery power.
When M3 is not in use for a certain period of time, it will
automatically enter into an idle mode or the LCD backlight turn-
off mode. To check the setting, click the power turn-off tab in
GO to Start > Settings > Control Panel> Power Or else, click
the light tab in GO to Start > Settings > Control Panel >Display.
If you set up a password in GO to Start > Settings > Control
Panel> Passwords and click the "Use Password when
System Start"check box, it will bring up the password input
window when M3 is turned on. If you enter the correct
password, it will be switched to the Start window. If you cannot
remember the password, you cannot start M3. In that case,
you have to execute a hardware reset. So it is important to
remember a password. (In particular, if you have forgotten the
password in the dial-up program, you cannot use the phone
function even if you carry out a hardware reset. So never forget
a password)
It is possible to display the owner information when M3 is
turned on and off. To switch to the Start window, click the
screen with a stylus pen. To modify the user information, click
GO to Start > Settings > Control Panel> User.
After clicking GO to Start > Settings > Control Panel> Volume
& Sound, click the volume to check out the sounds assigned to
the device movements. Also adjust the volume adjustment bar
When the