Clearing The Cimc Admin Password Using Jumper J45 - Cisco UCS C210 Installation And Service Manual
Generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (114 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Chapter
Clearing the CIMC Admin Password Using Jumper J45
This procedure describes how to clear the CIMC admin password back to the default in case the
user-selected password is lost of forgotten.
Step 1
Power off the server as described in the
page
Step 2
Disconnect all power cords from the power supplies.
Step 3
Slide the server out the front of the rack far enough so that you can remove the top cover. You might have
to detach cables from the rear panel to provide clearance.
Caution
Remove the top cover as described in the
Step 4
page
Move the shorting jumper to pins 2 and 3 of the J45 header (see
Step 5
Reinstall the top cover and reconnect AC power cords to the server. The server powers up to standby
Step 6
power mode, indicated when the Power LED on the front panel is amber.
Return the server to main power mode by pressing the Power button on the front panel. The server is in
Step 7
main power mode when the Power LED is green.
Note
Press the Power button to shut down the server to standby power mode, and then remove AC power cords
Step 8
from the server to remove all power.
Remove the top cover from the server.
Step 9
Remove the shorting jumper from the header pins.
Step 10
Note
Replace the top cover, replace the server in the rack, replace power cords and any other cables, then
Step 11
power on the server by pressing the Power button.
OL-20887-02
3-8.
If you cannot safely view and access the component, remove the server from the rack.
3-10.
You must allow the entire server to reboot to main power mode to complete the password reset.
This is because the state of the J45 jumper cannot be determined without the host CPU running.
The password is then cleared.
If you do not remove the jumper, the password is cleared every time that you power-cycle the
server.
"Shutting Down and Powering Off the Server" section on
"Removing and Replacing the Server Top Cover" section on
Figure 2-6 on page
Cisco UCS C210 Server Installation and Service Guide
2-15).
2-17
Advertisement
Table of Contents
