Hunter Fan Installation And Operation Manual page 24

®
AURORA AND TIFFANY LIGHT
FIXTURES (continued)
Note: Sub-step 1 applies to all light
fixtures. Sub-steps 2-7 apply to Tif-
fany and Aurora light fixtures. Refer
to Figures 8g.
1. Install bulbs.
2. Thread the fan switch pull chain
through the hole in the metal
disk.
3. Place globe on pipe until flush
against metal disk.
4. Thread the light switch pull chain
through the large center opening
of the globe.
5. Thread the fan switch pull chain
through the small center opening
in the globe.
6. Place the cover plate up against
the underside of the globe. Pass
light and fan switch pull chains
through the appropriate holes.
24
7. Thread the light switch pull chain
through the finial and screw the
cap onto the pipe end until tight.
Fan
Bulb
Switch
Socket
Pull Chain
Pipe
Globe
Metal Disk
Light
Switch
Pull Chain
Cover Plate
Finial
Figure 8g - Aurora Fixtures
INSTALLING ACCESSORY LIGHT
KITS
To install the light kit, follow the in-
structions included with the kit for
wiring, mounting, and assembly. Af-
ter completing the light kit installa-
tion, follow sub-steps 1 and 2 on
page 19 to reattach the lower switch
housing.
41343-01 7/1/2002