Hunter Fan Installation And Operation Manual page 13

4. Connect the wires as shown in Fig-
ure 4c. To connect the wires, twist
the bare metal leads together.
Place a wire nut over the inter-
twined length of wire and twist
clockwise until tight as shown.
CAUTION
Be sure no bare wire or wire
strands are visible after mak-
ing connections.
5. Separate the connected wires by
placing the green and white wires
on one side of the outlet box and
the black and the black/white
wires on the other side of the
outlet box.
6. Turn the connectors upward. Push
the wires gently into the outlet
box.
41343-01 41343-01 7/1/2002 6/12/2002
Wall Switch Wire For
Separate Control of Light Fixture
Black
Power
Wires
In
White
Ceiling
Bare or Green
2 x 4 Brace
Green
Approved
Connectors
2
Green Ground
Wire from Hanger
Pipe (not present
with flush mounting
option)
(Note: Wall switch
must be acceptable
as a general-use
switch.)
Outlet Box
Ceiling
Plate
1
Connections:
1 Connect Blk/Wht Wire from fan
to Wall Switch Wire for separate
Black/White
control of light fixture, or
Connect Blk/Wht Wire from fan
2
3 Wires
to Ceiling Black Wire if there
From Fan
is no separate Wall Switch Wire
for the light fixture.
Figure 4c - Wiring Diagram
®
13