Step 3 - Assembling The Fan - Hunter Fan Installation And Operation Manual

®

STEP 3 - ASSEMBLING THE FAN

Use the Step 3 instructions for the
type of mounting you have selected:
standard, angle, or flush.
STANDARD AND ANGLE MOUNTING
For Standard 8-foot Ceilings and
Higher
1. Insert the pipe through the
canopy as shown in Figure 3a.
Pipe
Canopy
Pipe
Setscrew
Figure 3a - Inserting Pipe through
Canopy
10
Feed wires from the fan through
the pipe.
2. Screw pipe into fan assembly un-
til tight. IMPORTANT! Tighten
pipe setscrew as shown in Figure
3a.
CAUTION
The pipe has a special coating
on the threads. Do not remove
this coating; the coating pre-
vents the pipe from unscrew-
ing. Once assembled, do not
remove the pipe.
FLUSH MOUNTING
For Low Ceilings
1. Fit the canopy over the motor
hanger adapter as shown in Fig-
ure 3b. Make sure the canopy fits
snugly against the fan assembly
with no space between the pieces.
2. You will find a large assembly
washer included with the fan.
Place the washer over the adapter
and canopy as shown in Figure 3b.
Assembly
Washer
Canopy
Adapter
Top of Fan
Figure 3b - Placing Canopy and
Washer Over Adapter
41343-01 7/1/2002