Step 5 - Hanging The Fan - Hunter Fan Installation And Operation Manual

®

STEP 5 - HANGING THE FAN

Sub-steps 1 and 2 apply to Flush, Stan-
dard, and Angle mounting. Sub-step
3 applies to Standard and Angle
mounting only.
1. Swing the fan up so as to align
the canopy screw holes with the
mounting holes on the ceiling
plate. Refer to Figure 5a.
Figure 5a - Attaching Canopy to
Ceiling Plate
14
2. Install and tighten the two #10-32
x 1/2" mounting screws.
3. For Standard and Angle Mount-
ing only: In addition to sub-steps
1 and 2, lift the fan housing to-
wards the ceiling and rotate the
fan until each canopy tab engages
a groove in the hanger ball as
shown in Figure 5b.
Note: If the tabs are already en-
gaged, do not rotate.
Ceiling
Plate
Failure to complete sub-steps
Canopy
1 through 3 could cause fan to
fall. (Sub-step 3 not applicable
for flush mounting.)
Groove in
Hanger
Ball
Canopy
Tab
Figure 5b - Canopy Tabs and Grooves
in Hanger Ball
WARNING
Groove in
Hanger Ball
41343-01 7/1/2002